I have to say I'm very stumped over this intallation. I'm moving a small UBB site to a Windows 2000 machine. I've read and completed all of the installation instructions and run the hello.cgi and diagnostic pages and everything comes back saying my system is OK to go. However, when I call up a .cgi page, I get a blank screen (no helpful error messages).

Here is the address if it helps...
http://208.171.247.67/pages/resource.asp?mode=6

Here are my general setting:
Script/Execute permissions set;
Active Perl installed;
All path names in the UltBB.setup file have been changed as well as any other paths mentioned in the install notes.

And yet I have lots of blank screen...?

Are there any other settings I can give you that will help?

If anyone has any suggestions please let me know because I've been on this problem days now and I'm not making much progress
Thanks

----------
Christmas came early -- I figured it out. Here's the solution incase anyone has the same problem. The scenario was that I was redirecting the www. address to another box. The direction was working fine in the rest of the site, however the BB uses frames and I noticed that in the frames the links were showing the named address instead of the IP address. I hard coded the IP address and all is well. This makes no sense because the named site is redirecting anyway. Go figure but it worked!
[This message has been edited by bbryans (edited 12-22-2000).]

[This message has been edited by bbryans (edited 12-22-2000).]

[This message has been edited by bbryans (edited 12-22-2000).]

it seems as if you got it to work?