I ran through the Threads 7.0.2 install last night, and all worked fine until I got to the end. I did not create an admin user, since I will be importing a Classic board.

However, once it completed the table creation phase, I got the message,
"All tables created. Your db is ready for import."
But I don't know where to go next. The install Guide describes "an optional Setup Wizard at the end of the installation", but I did not see anything on my browser page after the tables created message, and the Install Guide does not say where I should see it.

Where do I go now to create the boards, or do I just import everything from the old board?

If I need to import, where do I go to start that?

Is there a Control Panel I can access from the browser? But I have not created an admin user...

This guide should step you through the rest of the process.

Oh... thanks! I already have a hard-copy of that page. Just didn't look at it closely enough.