Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Printer & Scanner Accs
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Printer & Scanner Accs
i got one of these to replace ramps since ive had to keep fixing it with regulators and mosfets etc.. this board just works, no issues, no overheating.. no fan on it either. very well engineered and a top notch piece.. it runs the lcd12864 full graphics display with no problem at all.. do yourself a favor and get one of these gems if your tired of working on your printer and would rather be printing.. very good purchase. the price is excellent
Verified purchase: Yes | Condition: New
Built my own 3d printer and this board works great, accidentally shorted some of the wires while setting it up and testing, but it kept going. Works well at 250,000baud, and even hooked it up to a graphics screen and SD card reader. No problems programing it (used Arduino compiler), pushed 240W of power through it for the fans, extruder, heated bed, and motors and it runs warm but I just put a computer fan on top of it and not a single problem.
Verified purchase: Yes | Condition: New
Very good for repraps and anet printers. It's a good upgrade for 3d printers with cheap boards, easy to setup and use.
Verified purchase: Yes | Condition: New
Great item, don't buy ramps 1.4 + mega board. It caused too many issues for me. I hope to firgure out how to use lcd with marlin firmware.
Verified purchase: Yes | Condition: New
With twice the microcontroller memory and replaceable stepper motor drivers you can't beat this board as a very cost effective replacement for the controller board in the Ender series 3D printers.
Verified purchase: Yes | Condition: New