M.NT68676.2 LCD Controller Board Kit

• Notice: Please remember to leave us your LCD Model Number before placing the
  order, it is very import for us to prepare the right kit for you.
• PLEASE READ THIS CAREFULLY BERFORE YOU ORDER THE KIT:
• Please make sure the vertical and horizontal driver inside your LCD is still work, If it
  does not work our kit can not fix it.
  

• The driving circuit of LCD (marked as \" 1\" in following figure), The back light
  lamp(marked as\"2\")
  

• Please remember to leave us your LCD Model Number before placing the order, it is
  very import for us to prepare the right kit for you. How to find a right lcd model
  number Please check the following picture. They are LP171WU5(TL)(B1),LM201U04
  (A3)(K6), LM170E01(TL)(BB) and N133BGE-LB1. Their sizes are 17.1″,20.1″, 17″ and 13.3″.
• 
  

• Beside this kit, you will need to prepare the VGA cable/DVI cable/HDMI cable and
  power adapter yourself. If you need the power adapter, please buy item
  number:151314226569
• Because different LCD need different driver and working voltage,after you received
  the kit, please do not change any jumpers on the board, or use the kir for other LCD
  with different model number, otherwise you may damage your LCD. If you have any
  question or wantto use the kit for other LCD panel, please contact with us.
• Since different inverter board depends on your LCD panel model, and we may update
  

• the controller board a little bit, the kits you would receive may not exactly the same as pictured, please note!
  

• HOW TO CONNECT THE KIT
  

• Remove all circuit boards from the monitor.
  

• Connect 12VDC power to the board for LCD CCFL backlight lamp test, if the LCD
  panel lit up, it means the backlight of the LCD is working, then you can turn off the
  power and connect other wires. If the LCD does not lit up, then the backlight is
  brocken, you need to replace the lamps.
  

• ATTENTION:The high voltage strip has a output protection circuit,you have to
  connect all the wires properly and make sure the backlight is working, otherwis it will
  not work. If you only need to test the lamp, you can buy a high voltage strip specially
  for single lamp with item number:151320009442
  

• turn the power off，Harness connection: Match the mark
  on the harness pinhead with the pin #1 Mark on the
  board, (ATTENTION:Reverse connection may burn the
  screen).
• .

• Pay attention to the pinhead see if it is match up with the LVDS pinhead, watch the
  LVDS test points(those red circles in the picture), see if the number of circled point is
  same as the number of wires in blue /white, if you have any question please contact
  with us.
  

• The completed connnection:
  

• Connect VGA signal, turn on DC12 power, test the monior.
  

• LCD Controller Board x1
• LCD Inverter Board x1
• LVDS Cables x1
• 5-Keys Keypad x1