Store HomeView All ListingsAbout MeAdd to Favorite SellersSign Up for Newsletterresponse

Click photo to enlarge in new window.

DESCRIPTIONThisis anew hanger assembly forany traffic signal. May be used with 3-light signals, pedestrian cross walk signals, or single body 4-way signalswith a standard 2 inch hole.Assembly consists of the following items:

• (1) 3/8\" x 4\" eyelet (rated at 160 lbs.)
  
• (1) 3/8\" nut
• (1) 3/8\" self locking nut
• (2) 3/8\" x 2-1/2\" washers (static load tested at 250 lbs.)
  
• (6) 3/8\" x 1\" washers

Simply insert the eyelet with washers into your traffic light hole. Use the 3/8\" x 1\" washers for spacers to represent the thickness of your light. Assemble as shown in picture. Screw the self locking nut on leaving approximately 1/4\" thread exposed and tighten down the top exterior nut. Adjust the spacers as necessary so that the unit fits snugly. Some light housings may require additional 3/8\" x 1\" spacers depending on thickness. These can be picked up at most local hardware stores.

NOTE: This is to be used for decorative display of traffic lights only.

We have moretraffic signal parts and accessoriesin our store. Click here to see them all.PAYMENT DETAILS

Payments should be made within three days of close of sale. PayPal, Mastercard, or VISA payments are accepted.

DOMESTIC SHIPPING DETAILS

Shipping isUSPSor FEDEX.Other shipping methods may be available at an additional charge.All items are carefully packaged to prevent damage.

QUESTIONS?The answers to our most commonly asked questions can be found here.

© 2013. All Rights Reserved.

sale Template Created Free
at KD Web Page Design

.