Features:

(Because the output current of this product is less than 1mA, it is mainly corona discharge, which is not suitable for arcing. When working with no load, a 10M~100M ohm resistor should be connected in parallel at the high voltage output end)

Specifications and parameters:

Unlike the common 1-minute arcing modules on the market, the expensive price of this product is high stability, high efficiency and low heat, especially the 24V input type (rectangular type), which can truly achieve continuous discharge for 24 hours. This product is mainly used for scientific research experiments and is resistant Pressure test, electrostatic discharge, ionized gas, negative ions, corona ozone, ion wind, static electricity generation, etc.

Size:

Cylinder: 120*55*32

No-load power: 4W

Average load power: <8W

Maximum load power: <16W

Input voltage: 24V square

Load current: <1A

Output voltage: 30kV/40kV

Arc length: 2cm/3cm

Output current <1mA

(The power of the 30kv/40kv modules is the same, so the 40kv module current is slightly smaller)

Pulse frequency 3~10 times/sec

Package Contents:

1 xDC 24V to 40kV Pulse high voltage arc generator Boost transformer Ignition Coil