A Plug and Play ready PowerEdge RAID Controller H700 model with backup battery and 2x SATA III Breakout Cables. Everything needed to get up and running except for drives.This has been my old reliable, but I just moved to a newer setup for my home Plex Server and I have no need for this RAID Controller anymore. It handles SAS 6GB or SATA III drives, though proper cables are needed. What\'s included is enough to run the card in any consumer motherboard with SATA III drives. I ran it from 2017 until very recently with 8x 7200 RPM HGST Ultrastar Enterprise drives and it was reliable and stable the entire time.The PCIe Connector has B Pins 5 and 6 masked to prevent non-boots on older motherboards (was running on an X58 intel board). It MAY not need to be shrouded when installed on newer motherboards, and it\'s just tape so it comes right off.Excellent starter card if you need to expand your hard drive space. DOES NOT DO JBOD, DO NOT TRY TO FLASH THE CARD WITH IT MODE, IT WILL BRICK THE CARD. This is a hardware RAID Controller and does not support IT Mode JBOD pass through like the H200, H310, etc. Fully supports RAID 0,1,5,6,10,50, and 60.Can be set up and managed via it\'s own BIOS or MegaRAID Storage Manager (my preference).