Gets your Alta Labs Route10 10G router off the desk and into a 10 inch mini rack, so your gateway sits with your switch and patch panel instead of loose on a shelf. The front-mount design keeps the four 2.5G ports, both 10G SFP+ cages, and the reset accessible at the rack face, and the open sides clear the chassis for airflow. Good for homelabs, 10G home networks, and prosumer builds where you want the router mounted and out of the way.

**Compatible with:** Alta Labs Route10 (4-port 2.5G plus 2-port 10G SFP+ router).

This is a print-only mount. The router slides into the tray and the mount holds it at the rack face. Rack mounting hardware is not included, so use whatever screws your rack uses.

I 3D print this in PETG, not PLA, so it stands up to the heat this PoE router puts out far better than a budget PLA print would. A 19 inch version is also listed in my shop if you run a full-size rack. 💬 For any custom design requests please message me.