TESTING & COSMETIC NOTES:
This is a USED WORKING item in GOOD cosmetic condition that IS THOROUGHLY TESTED and is GUARANTEED WORKING
The unit has been reset to the factory default settings. See console log below.
COMPONENTS INCLUDED IN THIS sale:• (1) - CISCO CATALYST 2960-X 24-PORT 4SFP POE GIGABIT ETHERNET SWITCH WS-C2960X-24PS-L
• (1) - POWER CORD
REPLACEMENT or MONEY BACK GUARANTEE:When you receive a Guaranteed item from OC Depot, it should perform as described. In the rare situation that this is not the case, we will send a replacement upon safe return of the original item within 30 days of receiving the item. If a replacement is not available we will honor the terms of our Money-Back Guarantee.
ADDITIONAL INFORMATION: Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, C2960X Software (C2960X-UNIVERSALK9-M), Version 15.2(7)E5, R
ELEASE SOFTWARE (fc3)
Technical Support: http:/www.cisco.com/techsupport
Copyright (c) 1986-2021 by Cisco Systems, Inc.
Compiled Mon 13-Sep-21 09:41 by mcpre
Initializing flashfs...
Using driver version 4 for media type 1
mifs[7]: 12 files, 1 directories
mifs[7]: Total bytes : 1806336
mifs[7]: Bytes used : 834560
mifs[7]: Bytes available : 971776
mifs[7]: mifs fsck took 0 seconds.
mifs[7]: Initialization complete.
mifs[8]: 1 files, 1 directories
mifs[8]: Total bytes : 3870720
mifs[8]: Bytes used : 971264
mifs[8]: Bytes available : 2899456
mifs[8]: mifs fsck took 0 seconds.
mifs[8]: Initialization complete.
mifs[9]: 5 files, 1 directories
mifs[9]: Total bytes : 258048
mifs[9]: Bytes used : 8192
mifs[9]: Bytes available : 249856
mifs[9]: mifs fsck took 0 seconds.
mifs[9]: Initialization complete.
mifs[10]: 5 files, 1 directories
mifs[10]: Total bytes : 258048
mifs[10]: Bytes used : 8192
mifs[10]: Bytes available : 249856
mifs[10]: mifs fsck took 0 seconds.
mifs[10]: Initialization complete.
mifs[11]: 629 files, 21 directories
mifs[11]: Total bytes : 122185728
mifs[11]: Bytes used : 102190080
mifs[11]: Bytes available : 19995648
mifs[11]: mifs fsck took 1 seconds.
mifs[11]: Initialization complete.
...done Initializing flashfs.
Checking for Bootloader upgrade..
Boot Loader upgrade not needed(v)
FIPS: Flash Key Check : Begin
FIPS: Flash Key Check : End, Not Found, FIPS Mode Not Enabled
extracting front_end/front_end_ucode_info (43 bytes)
POST: MA BIST : Begin
POST: MA BIST : End, Status Passed
POST: TCAM BIST : Begin
POST: TCAM BIST : End, Status Passed
POST: ACT2 Authentication : Begin
POST: ACT2 Authentication : End, Status Passed
Waiting for Stack Master Election...
POST: Thermal, Fan Tests : Begin
POST: Thermal, Fan Tests : End, Status Passed
POST: PortASIC Stack Port Loopback Tests : Begin
POST: PortASIC Stack Port Loopback Tests : End, Status Passed
POST: PortASIC Port Loopback Tests : Begin
POST: PortASIC Port Loopback Tests : End, Status Passed
POST: EMAC Loopback Tests : Begin
POST: EMAC Loopback Tests : MAC Loopback Passed
POST: EMAC Loopback Tests : PHY Loopback Passed
POST: EMAC Loopback Tests : End, Status Passed
Election Complete
Switch 2 booting as Master
Waiting for Port download...Complete
Initializing Port Extension Feature Support...
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
If you require further assistance please contact us by sending email to
export@cisco.com.
cisco WS-C2960X-24PS-L (APM86XXX) processor (revision E0) with 524288K bytes of
memory.
Processor board ID FOC1837S30U
Last reset from power-on
1 Virtual Ethernet interface
1 FastEthernet interface
28 Gigabit Ethernet interfaces
2 Ten Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
512K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 34:6F:90:58:60:80
Motherboard assembly number : 73-15972-02
Power supply part number : 341-0528-01
Motherboard serial number : FOC18365ZSB
Power supply serial number : DCB1831710J
Model revision number : E0
Motherboard revision number : B0
Model number : WS-C2960X-24PS-L
Daughterboard assembly number : 73-14200-03
Daughterboard serial number : FOC18361XQN
System serial number : FOC1837S30U
Top Assembly Part Number : 800-41469-01
Top Assembly Revision Number : B0
Version ID : V02
CLEI Code Number : CMMLR00ARB
Daughterboard revision number : A0
Hardware Board Revision Number : 0x12
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 2 30 WS-C2960X-24PS-L 15.2(7)E5 C2960X-UNIVERSALK9-
M
Press RETURN to get started!
*Mar 1 00:01:02.991: Read env variable - LICENSE_BOOT_LEVEL =
*Jan 2 00:00:00.150: Module nam
e = c2960x_lanbase Next reboot level = lanbase and License = lanbase
Sep 1 23:07:18.508: Flexstack module is 1
Sep 1 23:08:05.397: %STACKMGR-4-SWITCH_ADDED: Switch 2 has been ADDED to the st
ack
Sep 1 23:08:06.917: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, chan
ged state to down
Sep 1 23:08:06.917: %LINEPR
--- System Configuration Dialog ---
Enable secret warning
----------------------------------
In order to access the device manager, an enable secret is required
If you enter the initial configuration dialog, you will be prompted for the enab
le secret
If you choose not to enter the intial configuration dialog, or if you exit setup
without setting the enable secret,
please set an enable secret using the following CLI in configuration mode-
enable secret 0
--------OTO-5-UPDOWN: Line protocol on Interface FastEthernet0, changed state to
down
Sep 1 23:08:11.877: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type
vlan
Sep 1 23:08:13.674: %PNP-6-PNP_DISCOVERY_STARTED: PnP Discovery started
Sep 1 23:08:38.175: %STACKMGR-5-SWITCH_READY: Switch 2 is READY
Sep 1 23:08:38.175: %STACKMGR-4-STACK_LINK_CHANGE: St--------------------------
Would you like to enter the initial configuration dialog? [yes/no]:
% Please answer 'yes' or 'no'.
Switch> Please Click Here to Visit Our StoreSearchBy6 - 253736 | Loc: IB3 | L: Mitchell |T: | PM: Nick | QTY: 0| Plan: 50/50 NET of FEES FREESHIP |20.00"x18.00"x5.00"21.00lbs |Start: $0.00 | BIN: $119.99 | |9/6/2023 ||Computers/Tablets & Networking::Enterprise Networking, Servers::Switches & Hubs::Network Switches
