User ProCurve Switch 2650# show versionImage 22 2002 Image:Primary
HP ProCurve Switch 2650# show and Counters - General System Information
System Name: HP ProCurve Switch 2650
System Contact:
System Location:
MAC Age Time (sec) : 300
Time Zone: 0
Daylight Time Rule : revision: H.07.02Base MAC Addr: 00306e-893000
ROM Version: H.07.01Serial Number:
Up Time: 75 secsMemory- Total: 20,457,280
CPU Util (%): 99Free: 16,568,624
IP Mgmt- Pkts Rx : 0Packet- Total: 1998
Pkts Tx : 0BuffersFree: 1880
Lowest: 1869
Missed: 0
HP ProCurve Switch 2650# show arp
IP ARP table
IP AddressMAC AddressTypePort
--------------- ----------------- ------- ----
HP ProCurve Switch 2650# show accounting
Status and Counters - Accounting : 0
Suppress Empty User : No
Type| Method Mode
------- + ------ ------------
Network | None
Exec| None
System| None
HP ProCurve Switch 2650# show authentication
Status and Counters - Authentication Information
Login Attempts : 3
| LoginLoginEnableEnable
Access Task | + ---------- ---------- ---------- ----------
Console| LocalNoneLocalNone
Telnet| LocalNoneLocalNone
Port-Access | Local
SSH| ProCurve Switch 2650# show console
Console/Serial Link
Inbound Telnet Enabled [Yes] : Yes
Web Agent Enabled [Yes] : Yes
Terminal Type [VT100] : VT100
Screen Refresh Interval (sec) [3] : 3
Displayed Events [All] : All
Baud Rate [Speed Sense] : speed-sense
Flow Control [XON/XOFF] : XON/XOFF
Session Inactivity Time (min) [0] : 0
HP ProCurve Switch 2650# show cdp
Global CDP information
Enable CDP [Yes] : Yes
CDP Hold Time [180] : 180
CDP Transmit Interval [60] : 60
Port CDP
---- ProCurve Switch 2650# show config
Startup configuration:
; J4899A Configuration Editor; Created on release #H.07.02
hostname "HP ProCurve Switch 2650"
snmp-server community "public" Unrestricted
vlan 1
name "DEFAULT_VLAN"
untagged 1-50
ip address ProCurve Switch 2650# show fault-finder
Fault Finder
Fault IDSensitivity Action
--------------- ----------- ProCurve Switch 2650# show -------
Primary Image: 197771110/22/02 H.07.02
Secondary Image : 197771110/22/02 H.07.02
Boot Rom Version: H.07.01
Current Boot: Primary
HP ProCurve Switch 2650# show gvrp
GVRP support
Maximum VLANs to support [8] : 8
Primary VLAN : DEFAULT_VLAN
GVRP Enabled [No] : No
HP ProCurve Switch 2650# show ip
Internet (IP) Service
IP Routing : Disabled
Default Gateway :
Default TTL: 64
VLAN| IP ConfigIP AddressSubnet Mask
------------ + ---------- --------------- ---------------
DEFAULT_VLAN | ProCurve Switch 2650# show ProCurve Switch 2650# show Log listing: Events Since Boot----
I 01/01/90 00:00:02 system: 01/01/90 00:00:02 system: System went down:01/01/90 00:00:38
I 01/01/90 00:00:02 system: Operator cold reboot from CONSOLE session.
I 01/01/90 00:00:15 lacp: Passive Dynamic LACP enabled on all ports
I 01/01/90 00:00:15 stack: Stack Protocol enabled
I 01/01/90 00:00:16 dhcpr: DHCP relay agent feature enabled
I 01/01/90 00:00:16 tftp: Enable succeeded
I 01/01/90 00:00:16 system: System Booted.
I 01/01/90 00:00:16 cdp: CDP enabled
I 01/01/90 00:00:24 mgr: SME CONSOLE Session - MANAGER Mode established
----Bottom of Log : Events Listed = 10----
HP ProCurve Switch 2650# show mac-address
Status and Counters - Port Address Table
MAC AddressLocated on Port
------------- ---------------
HP ProCurve Switch 2650# show management
Status and Counters - Management Address Server Address : Disabled
Default Gateway:
VLAN NameMAC Address| IP Address
------------ ------------------- + -------------------
DEFAULT_VLAN 00306e-893000|
HP ProCurve Switch 2650# show name
Port Names
Port TypeName
---- --------- assigned
210/100TXnot assigned
310/100TXnot assigned
410/100TXnot assigned
510/100TXnot assigned
610/100TXnot assigned
710/100TXnot assigned
810/100TXnot assigned
910/100TXnot assigned
1010/100TXnot assigned
1110/100TXnot assigned
1210/100TXnot assigned
1310/100TXnot assigned
1410/100TXnot assigned
1510/100TXnot assigned
1610/100TXnot assigned
1710/100TXnot assigned
1810/100TXnot assigned
1910/100TXnot assigned
2010/100TXnot assigned
2110/100TXnot assigned
2210/100TXnot assigned
2310/100TXnot assigned
2410/100TXnot assigned
2510/100TXnot assigned
2610/100TXnot assigned
2710/100TXnot assigned
2810/100TXnot assigned
2910/100TXnot assigned
3010/100TXnot assigned
3110/100TXnot assigned
3210/100TXnot assigned
3310/100TXnot assigned
3410/100TXnot assigned
3510/100TXnot assigned
3610/100TXnot assigned
3710/100TXnot assigned
3810/100TXnot assigned
3910/100TXnot assigned
4010/100TXnot assigned
4110/100TXnot assigned
4210/100TXnot assigned
4310/100TXnot assigned
4410/100TXnot assigned
4510/100TXnot assigned
4610/100TXnot assigned
4710/100TXnot assigned
4810/100TXnot assigned
49100/1000T not assigned
50100/1000T not assigned
HP ProCurve Switch 2650#show port-security
Port Security
Port Learn Mode| Action
---- -------------------- + None
2Continuous| None
3Continuous| None
4Continuous| None
5Continuous| None
6Continuous| None
7Continuous| None
8Continuous| None
9Continuous| None
10Continuous| None
11Continuous| None
12Continuous| None
13Continuous| None
14Continuous| None
15Continuous| None
16Continuous| None
17Continuous| None
18Continuous| None
19Continuous| None
20Continuous| None
21Continuous| None
22Continuous| None
23Continuous| None
24Continuous| None
25Continuous| None
26Continuous| None
27Continuous| None
28Continuous| None
29Continuous| None
30Continuous| None
31Continuous| None
32Continuous| None
33Continuous| None
34Continuous| None
35Continuous| None
36Continuous| None
37Continuous| None
38Continuous| None
39Continuous| None
40Continuous| None
41Continuous| None
42Continuous| None
43Continuous| None
44Continuous| None
45Continuous| None
46Continuous| None
47Continuous| None
48Continuous| None
49Continuous| None
50Continuous| None
HP ProCurve Switch 2650# show radius
Status and Counters - General RADIUS : 0
Timeout(secs) : 5
Retransmit Attempts : 3
Global Encryption Key IP AddrPortPortEncryption Key
--------------- ----- ----- ProCurve Switch 2650# show running-config
Running configuration:
; J4899A Configuration Editor; Created on release #H.07.02
hostname "HP ProCurve Switch 2650"
cdp run
snmp-server community "public" Unrestricted
vlan 1
name "DEFAULT_VLAN"
untagged 1-50
ip address ProCurve Switch 2650# show snmp-server
SNMP Communities
Community NameMIB View Write Access
---------------- -------- Receivers
Send Authentication Traps [No] : Sent in Trap
---------------------- ---------------- ProCurve Switch 2650# show sntp
SNTP Configuration
Time Sync Mode: Timep
SNTP Mode : disabled
Poll Interval (sec) [720] : 720
HP ProCurve Switch 2650# show spanning-tree
Status and Counters - Spanning Tree Information
Protocol Version : RSTP
STP Enabled : No
Port TypeCostPriority State| Designated Bridge
---- --------- --------- -------- ---------- + ProCurve Switch 2650# show stack
Stacking - Stacking Status (This Switch)
Stack State: Candidate
Transmission Interval : 60
Auto Join: Yes
HP ProCurve Switch 2650# show cpu
22 percent busy, from 735 sec ago
1 sec ave: 14 percent busy
5 sec ave: 14 percent busy
1 min ave: 13 percent busy
HP ProCurve Switch 2650# show tacacs
Status and Counters - TACACS Information
Timeout : 5
Encryption Key :
Server IP AddrOpensCloses Aborts Errors Pkts Rx Pkts Tx
--------------- ------ ------ ------ ------ ------- -------
HP ProCurve Switch 2650# show telnet
Telnet Activity
Session Privilege FromTo
------- --------- --------------- ---------------
**1 ManagerConsole
HP ProCurve Switch 2650# show terminal
Terminal width: 80 length: 24
HP ProCurve Switch 2650# show timep
Timep Configuration
Time Sync Mode: Timep
TimeP Mode [Disabled] : Disabled
HP ProCurve Switch 2650# show trunks
Load Balancing
Port | NameType| Group Type
---- + -------------------------------- --------- + ----- -----
HP ProCurve Switch 2650# show vlan
Status and Counters - VLAN Information
Maximum VLANs to support : 8
Primary VLAN : DEFAULT_VLAN
Management VLAN :
802.1Q VLAN ID NameStatus
-------------- ------------- Specifications Functional Condition:
F3 - Key Functions Working
Equipment in this category has undergone testing to confirm that its core functionalities are operational. Essential functions that a typical user would expect are verified working. Secondary functions or software may not be present or configured. Units may be missing components or parts that are not essential to key functions.
Cosmetic Condition:
C4 - Used Good Good overall used condition. Some light scratches or scuffs. No dents, dings or cracks.
Data Sanitization:
S3 - Data Clear Device has been sanitized by one of the following methods: Factory Reset, NIST 800-88 Clear, or DOD 5220.22
Mpn
J4899A Function Tests Powers On
Passed Physical Inspection
Passed Functions
Passed Buttons
Passed Shipping
Tracking information is automatically uploaded to once your order ships.
We ship orders within the contiguous US with FedEx or USPS at our discretion. We use 's shipping calculator for all shipping rates.
PO Box, HI, AK, APO/FPO/DPO, and PR orders must be shipped via USPS. Please contact us or request an adjusted invoice before checking out. Local Pickup
If you have purchased an item and prefer to pick it up, please select “Local Pickup” from the shipping options during checkout. Then please contact us to arrange pickup.
Payment must be made through prior to pickup. Combined Shipping
We can typically provide a 30% shipping discount for multiple purchases that will fit in the same box.
For combined shipping, please click 'Request Total' or send us a message before checking out.
We can then adjust your invoice for combined shipping. Expedited Shipping
In order to guarantee the rates and transit times shown, we must receive your order with its payment cleared by 12:00 PM EST during business days.
Orders placed after 12:00 PM EST will be shipped on the next business day.
Orders placed on weekends or holidays will be shipped the next business day.
Please plan your orders accordingly.
Returns
We strive to be a 5 star seller and hope that you are happy with your purchase.
If there is a problem with your order, please contact us through messages or by phone before leaving response. For items that are tested and working properly:
Our return window for working items listed as "New" or "Used" is 30 days.
If the item is no longer wanted or does not fit, the buyer is responsible for return shipping.
If the item is not working as described, we will work with you on the issue, please contact us to resolve. Please review all product details and sale terms before making a purchase.
