Sun Ultra 2 Workstation Motherboard - 0MB Memory - 0GHz Memory
Part# 501-3132Model: A14Manufacturer: Sun MicrosystemsDescription: Ultra 2 Motherboard - 0GHz - 0MB - Dual CPU SupportNVRAM:will need to be replacedCondition: Clean, Pull
Specifications:

• Dual UPA CPU Slot (200MHz / 300MHz / 400MHz Support)
• 16x 200-Pin 60ns 5V ECC Memory Slots
• 4x SBus Expansion Slots
• 1x FFB UPA Connector (Creator Graphics)
• External HD68 SCSI
• External HD40 Din-8
• Parallel DB25
• Audio
• Includes 540-2603 Fan Shroud

You are purchasing the Sun 501-3132 Ultra 2 Motherboard pictured, Serial# 159042.
Supported Ultra 2 CPUs:

• X1188A - 501-4791 - 200MHz UltraSPARC Module
• X1188A - 501-3041 - 200MHz UltraSPARC Module
• X1191A - 501-4196 - 300MHz UltraSPARC Module
• X1191A - 501-4849 - 300MHz UltraSPARC Module
• X1194A - 501-5541 - 400MHz UltraSPARC Module
• X1194A - 501-5445 - 400MHz UltraSPARC Module
• CPUs are not included.

Supported Ultra 2 Memory:

• 501-2479 - 16MB DIMM X7001A
• 501-2622 - 32MB DIMM X7002A
• 501-2480 - 64MB DIMM X7003A
• 501-5691 - 64MB DIMM X7043A
• 501-3136 - 128MB DIMM X7004A
• Memory Not included.

Manufacturer Notes:

1. The minimum operating system is Solaris 2.5.1.
2. OBP 3.11 is required if Solaris 2.7 is used in 64-bit mode.
3. The flash PROM is soldered to the system board.
4. Use the Flash PROM Programming Utility to update the flash PROM.

Manufacturer Graphics Notes:

1. FFB2+ is not compatible with 300MHz Module 501-4196.
2. FFB2+ is not compatible with 300MHz Module <=501-4849-02.
3. Elite3D is not compatible with 300MHz Module 501-4196.
4. Elite3D is not compatible with 300MHz Module <=501-4849-02.

Manufacturer Memory Notes:

1. Two pairs of SIMMs form a Group.
2. All four SIMMs within a Group must be the same size.
3. The minimum memory requirement is four SIMMs in Group 0.
4. SIMMs can be installed in Group 1, Group 2, or Group 3 in any order.
5. A Group addresses 512MB of memory. Unused memory is mapped out.
6. OBP <= 3.1.3 reports memory errors as a pair of SIMMs.
7. OBP <= 3.1.3 reports the wrong SIMM pair when a memory error occurs. Refer to BugID 1262941.
8. OBP 3.1.5 reports memory errors as a single SIMM.

Internal SCSI Bus Notes:

1. The SCSI controller is connected to J1202, J3201, and J3202.
2. There is no termination at J1202, J3201, or J3202.
3. The internal SCSI bus is terminated at J1203.
4. Connect J1202 to J1203 with cable 530-1451 or CD-ROM/Tape Drive cable 530-2137 to terminate the internal SCSI bus.

You are purchasing the Sun 501-3132 Ultra 2 motherboard pictured.
Guaranteed Working.
Ships SAFE and Fast!!!