UBB Store

Conner Peripherals 210MB - CFS210A 3.5
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Conner Peripherals 210MB - CFS210A 3.5" IDE HARD DRIVE VINTAGE RARE TESTED
Price: LV $150.00
Vintage RARE COLLECTIBLE item- WORKING !!! This hdd is tested for surface test in 2 Disk Scanner programs -see test results in ScreenshotsSoftware used to scan :1. Hard Disk Sentinel - Reinitialise disk surface test (ZERO FILL )( see screenshots)
2. HD Tune Pro - Error Scan test & SPEED MAP TEST ( see screenshots )
No Bad BlocksFormatted -FAT32Hard Disk Summary
Hard Disk Number,4
Interface,IDE/ATA
Disk Controller,"Standard Dual Channel PCI IDE Controller (ATA) [VEN: 197B, DEV: 2368]"
Disk Location,"Channel 0, Target 0, Lun 0, Device: 0"
Hard Disk Model ID,Conner Peripherals 210MB - CFS210A
Firmware Revision,6BT8.26p
Hard Disk Serial Number,CC9LSBR
Total Size,196 MB
Power State,ActiveATA Information
Hard Disk Cylinders,685
Hard Disk Heads,16
Hard Disk Sectors,38
ATA Revision,0
Total Sectors,0
Bytes Per Sector,649
Buffer Size,32 KB
Multiple Sectors,32
Error Correction Bytes,4
Unformatted Capacity,258 MB
Maximum PIO Mode,1
Active PIO Mode,1
Maximum Multiword DMA Mode,0
Maximum UDMA Mode,0
Minimum multiword DMA Transfer Time,150 ns
Recommended Multiword DMA Transfer Time,150 ns
Minimum PIO Transfer Time Without IORDY,270 ns
Minimum PIO Transfer Time With IORDY,180 ns
ATA Control Byte,Invalid
ATA Checksum Value,InvalidAcoustic Management Configuration
Acoustic Management,Not supported
Acoustic Management,Disabled
Current Acoustic Level,Default (00h)
Recommended Acoustic Level,Default (00h)ATA Features
Read Ahead Buffer,"Supported, Disabled"
DMA,Supported
Ultra DMA,Not supported
S.M.A.R.T.,Not supported
Power Management,Not supported
Write Cache,Not supported
Host Protected Area,Not supported
Advanced Power Management,Not supported
Extended Power Management,Not supported
Power Up In Standby,Not supported
48-bit LBA Addressing,Not supported
Device Configuration Overlay,Not supported
IORDY Support,Supported
Read/Write DMA Queue,Not supported
NOP Command,Not supported
Trusted Computing,Not supported
64-bit World Wide ID,Not supported
Streaming,Not supported
Media Card Pass Through,Not supported
General Purpose Logging,Not supported
Error Logging,Not supported
CFA Feature Set,Not supported
CFast Device,Not supported
Long Physical Sectors (1),Not supported
Long Logical Sectors,Not supported
Write-Read-Verify,Not supported
NV Cache Feature,Not supported
NV Cache Power Mode,Not supported
NV Cache Size,Not supported
Free-fall Control,Not supported
Free-fall Control Sensitivity,Not supportedSSD Features
Data Set Management,Not supported
TRIM Command,Not supported
Deterministic Read After TRIM,Not supportedOff-line Data Collection Status,Never Started
Self Test Execution Status,Successfully Completed
Total Time To Complete Off-line Data Collection,0 seconds
Execute Off-line Immediate,Not supported
Abort/restart Off-line By Host,Not supported
Off-line Read Scanning,Not supported
Short Self-test,Not supported
Extended Self-test,Not supported
Conveyance Self-test,Not supported
Selective Self-Test,Not supported
Save Data Before/After Power Saving Mode,Not supported
Enable/Disable Attribute Autosave,Not supported
Error Logging Capability,Not supportedSecurity Mode
Security Mode,Not supported
Security Erase,Not supported
Security Erase Time,Not supported
Security Enhanced Erase Feature,Supported
Security Enhanced Erase Time,0 minutes
Security Enabled,No
Security Locked,Yes
Security Frozen,Yes
Security Counter Expired,No
Security Level,HighSerial ATA Features
S-ATA Compliance,No
S-ATA I Signaling Speed (1.5 Gps),Not supported
S-ATA II Signaling Speed (3 Gps),Not supported
S-ATA Gen3 Signaling Speed (6 Gps),Not supported
Receipt Of Power Management Requests From Host,Not supported
PHY Event Counters,Not supported
Non-Zero Buffer Offsets In DMA Setup FIS,Not supported
DMA Setup Auto-Activate Optimization,Not supported
Device Initiating Interface Power Management,Not supported
In-Order Data Delivery,Not supported
Asynchronous Notification,Not supported
Software Settings Preservation,Not supported
Native Command Queuing (NCQ),Not supported
Queue Length,Not supportedDisk Information
Disk Family,Bobcat
Form Factor,"3.5"" "
Capacity,"213.4 MB (213.4 x 1,000,000 bytes)"
Number Of Disks,1
Number Of Heads,2
Rotational Speed,3600 RPM
Rotation Time,16.67 ms
Average Rotational Latency,8.33 ms
Disk Interface,IDE-AT
Buffer-Host Max. Rate,7.5 MB/seconds
Buffer Size,32 KB
Drive Ready Time (typical),6 seconds
Average Seek Time,14.0 ms
Track To Track Seek Time,3.0 ms
Full Stroke Seek Time,25.0 ms
Width,101.6 mm (4.0 inch)
Depth,146.1 mm (5.8 inch)
Height,25.4 mm (1.0 inch)
Weight,450 grams (1.0 pounds)
Required power for spinup,? mA
Power required (seek),? W
Power required (idle),? W
Power required (standby),? W
Manufacturer,Seagate Technologysold for collection or for test or for donor drive or scrap..............What you see pictured are the exact Hard Drive IDE you will receive
Return policy:Lot is sold "as is" NO RETURNS ,NO WARRANTY,NO REFUNDSShipping & handling:Standart shipping with tracking


Buy Now