Simply put: The Last 2U Rails you will need for your data center!24" to 31"adjustable and a sturdy 1.25" galvanized steel shelf on all 4 corners.
New18GA Designis thicker and stronger! LASER CUT to EXACT specifications!
These are 3 SETS(2 pieces left and 2 pieces right) of Generic+Universal 2U Rails from American Rails(US).Again, this listing will deliver 3 SETS to hold an equivalent of 6x1U servers or 3X2U servers.
They are called Version 3 "Tall" because for added strength, they extend nearly to the bottom of the above 2U position.
Compatible withCompaq, SuperMicro, Dell, IBMand more(almost any server, really)!
The'Shelf Support'is 1.25" underneath and 11" front to back(Depth) on ALL 4 SIDES.That's 55 square inches of support for your servers!
BIG ADVANTAGES over ALL other rails:1.) Put these rails inONCE with 2-3 mounting boltson each corner(min 8) and you'llNEVER have to re-raila cabinet again!2.) They are made to support a FULL CABINET(FULL 42U rack/cabinet density)!3.) These support the Front and Back of the server with a 1.25" footer(shelf).
Other "universal rails" have two fundamental flaws because they are designed with an offset from the 1U bottom(foot) which wastes nearly 1/2" vertical space. This means that by design you will NOT be able to get a cabinet FULL with 42U.
Other APC rails require skipping a slot! That means for every 2U APC installed, you waste 1U on spacing.Wasted space means wasted ventilation and floor space.Be Aware of diluting your investment!The American Rails(US) 2U rails are UNIVERSAL: No more dealing with side rail sets that require screwing into the case No more highly specific bearings that break No more difficult release pins to pull a server outStackone 2U server or two 1U serversin the same spot.
Made from18GA Galvanized steel, they can supportup to 100 lbs!Two locking nuts on each side can be tightened with Phillips head screwdriver and will never need to be reconfigured.No special tools involved for permanent setup.
They areautomatically centered on a 24" depth.With your choice of 6(Six) Standard Rack bolt holes on each collar, there are many options for securing to cabinet.They can support cabinet depth(front to back) from 24" to 31".
The mounting holes fit most modern racks and can hold 1x2U server or 2x1U servers.
Easy to install with your existing cabinet nuts and mounting bolts.Also,no need to mount anything to the side of your server, just slide these into position and you are done!
Manufactured is Atlanta, GA!
Let us know if you have need of larger quantities!