Name:

Newly upgraded Ender-3/CR-10/ A8 hotbed printing platform,1 Side PEI textured plate + 1 Side PEO smooth printing surface

Size:

220x220mm /235x235mm /310x310mm (with magnetic base)

Instructions:

1. For the first printing, it must be leveled (the distance between the nozzle and the hot bed is generally A4 paper thickness)

2.Tear off the adhesive on the base of the magnetic sticker and stick it on the hot bed platform, pay attention to be flat and do not leave air bubbles.

3. Adsorb the PEI side or the PEO side spring steel plate on the magnetic base

4.Start printing, the temperature of the hot bed can be set to 40°C-80°C according to the actual situation (do not exceed 80°C)

5. Take off the printing surface and bend it gently to achieve easy demoulding.

Advantage:

1. Double-sided printing, convenient and practical

2, High temperature resistance, scratch resistance, no deformation

3. No glue, easy to use

4. Anti-warping and strong stickiness

5. Stainless spring steel, good flatness

6. The printed model can be removed without the help of other tools, can be bent and returned to a flat state, no loss mode.

7. Easy to clean, just wipe it off with a wet tissue or alcohol before printing

Note:

1.DO NOT USE ACETONE ON POWDER COATED PEI SIDE!!!!

Package including:

1 Set Spring Steel Sheet pre-applied PEO Sheet+with Magnetic Rubber Plate.

Maintenance:

Wipe the print surface before and after a print with Isopropyl alcohol to maintain a clean surface for maximum bed adhesion strength. As with any build surface, make sure you are not printing too close to the bed to avoid possibly infusing the filament into the build surface.

3.Please contact usfirst before you leave Neutral or Negative response. We will do our best to solve the problem, thanks! ​