Sunhans 3W 11b/g/n tri band wireless signal amplifier/wireless WIFI amplifierSunhans wireless signal amplifier is suitable for home/office and public places, suitable for wireless aerial modeling/photography, wireless monitoring equipment.
Product parameters:Supporting standards: IEEE802.11 B/G/NFrequency of 2500 MHz: 2400-2500MHzImpedance: 50 ΩRF output power: 3000MW [35dBm]Emission gain: 13-17 decibelsReceiver gain: 8-12dBNoise factor: 3.0 decibels (typical value)Working temperature: -40 ° C to+70 ° CWorking humidity: up to 95 ° CShell: AluminumWeight: 400gSize: 6.5X3.0 x 1.5 cmUsage:1. First, remove the antenna from the wireless AP or wireless router.2. Take out the SMA cable (RG316) and connect the wireless AP (wireless router or wireless network card) to the TO Radio port of the signal amplifier.3. Connect an antenna to the other end of the signal amplifier (TO Antenna).4. Plug in the power and it's done.Frequently asked questions1. How much signal can be amplified by adding this product?Answer: The power of our ordinary home wireless router is generally 80-100mW (milliwatts). After adding this product, the maximum power output can reach 2500mW (milliwatts). You can imagine the effect and function of adding this product to your own environment!2. What kind of wireless product can support this product?Answer: Our product supports 2.4GHz WLAN 802.11b, 802.11b+, 802.11g, 802.11b+g+N, wireless 2.4G AP, 2.4G wireless bridge, 2.4G wireless router, 2.4G wireless network card, 2.4G wireless monitoring, 2.4G wireless microphone, 2.4G Bluetooth device, etc.3. Can the router be encrypted after adding this product?Answer: Any encryption such as WEP/WPA/WPA2 can be supported!4. Is this product suitable for outdoor use?Answer: This product cannot be placed outdoors! But it can be packed in a waterproof box!5. What is the difference between 2.4bg and 2.4bgN?Answer: The maximum transmission rate of 2.4BG is 54MB, but the maximum transmission rate of 2.4BGN is 150MB, which is much better than BG in terms of relative bandwidth. The prerequisite is that your router must support BGN specification routers to achieve this. If you are using BG specification routers, the maximum output is still 54MB6. Special precautions:Answer: Power amplifiers are not suitable for use on devices with higher power output, as products with higher power output will produce higher power. Installing them on this product can actually cause saturation protection and signal distortion, which can have the opposite effect. It is strongly recommended to use them on devices with lower power output for better and more noticeable results.