Product parameters:
Model: OC-H06DFlow: 600L/H
Lift: 5M±0.5M
Working voltage: DC12V
Noise: ≤25DB
Color: Black
Material: POM+ Acrylic + Aluminum
Bearing: Ceramic
Inlet/Outlet: G1/4 thread
Sealing: ≤ 0.2mpa
Power port: Small 4pin, PWM
Rated power: 9.6W
Rated current: 0.81A±5%Application: Computer/3D printer water cooling systemNote to buyers:
1. When filling the liquid, it is necessary to start the pump power repeatedly for several times. This operation helps to drive the liquid into the loop and expel the air.
2. Do not idle the pump! If there is no liquid, turn off the pump power immediately to avoid damage to the pump.
3. When testing for water leakage, place a paper towel or towel at the joint of the pipe connector to locate the water leakage.
4. After the liquid is added, please open the interface screw above the reservoir, and let the water cooling loop continue to circulate for 24 hours, so that the gas can effectively discharge from the water cooling system.We are reliable seller and we have our professional after-sale service for all of our customs. If there is any question about the order,please contact us in advance ,we will always here until you get a happy answer.
About services:
1.Please check the package and item when you get carefully to make sure there is no problem.
2. If you have any problem or are not entirely satisfied with your package,please don’t be hesitate to contact us first before leaving negative response. We will resolve the problem to satisfy you.