Ceramic Hotend for Elegoo Centauri Carbon with 0.2MM 0.4MM Brass-Hardened Steel Nozzle
package includes:
0.4MM Ceramic Hotend Kit x1 (The hot end kit has been pre assembled)
0.2MM Ceramic Hotend Kit x1
0.4MM Brass nozzle x1
0.6MM Brass nozzle x1
0.8MM Brass nozzle x1
0.2MM Brass nozzle x1
silicone sleeve x2
nozzle brush x2
Kit Tools x1
Compatibility: 2-pack 0.2MM and 0.4MM for Elegoo Centauri Carbon hotend kit pre-assembled (includes hardened steel bimetallic nozzle, heating block, ceramic heating element, thermistor, heat sink, silicone sleeve). you can easily replace the entire old hot end without disassembling it separately. please confirm your 3D printer model before purchasing
Application: When your for Centauri Carbon Ceramic Hotend frequently plugs, extrusion flow fluctuates, leaks, or temperature calibration fails, it may be caused by poor heat dissipation of the throat tube, aging of the heating block or thermistor failure, and thermistor needs to be replaced as a whole to avoid affecting printing stability
Upgraded Version: for Centauri Carbon hot end uses ceramic heating plate and oxide coating heat sink, it can reach the working temperature in a short time, greatly shortening the preheating waiting time. the high temperature resistance effectively ensures the stability of high temperature printing. high temperature oxidation process improves heat radiation efficiency by 15% compared to non-oxidation heat sinks
You Will Receive: 1Pc 0.4MM hardened steel bimetallic nozzle hotend kit(pre-assembled), 1Pc 0.2MM hardened steel bimetallic nozzle hotend kit, 0.2/0.4/0.6/0.8MM brass nozzle 1 each, 2pcs silicone sleeves and nozzle brushes, and 1 set of removal tools. a variety of nozzle sizes are perfect for switching between fine details and fast batch printing for DIY fun. If you have any questions, please leave a message on Amazon
Notice: 1. Please turn off the power supply and make sure the hot end cools to room temperature before replacing to avoid burns at high temperature. 2. check that the received for Elegoo Carbon hotend print head extruder kit is tight, as looseness may occur during delivery. 3. after replacement, please recalibrate the parameters, keep the bed in level and do a test print