Fumbling with an iPad on your lap during a cross-country flight or propping it against the glareshield on approach is a distraction no pilot needs. ProAviator is a purpose-built cockpit mount for GA pilots who need a secure, adjustable place for their EFB. The 4-inch curved arm helps position your screen without unnecessary cockpit bulk, while the spring-loaded cradle fits most 7 to 12.9 inch tablets, including iPad Mini, iPad Air, iPad Pro 11-inch, iPad Pro 12.9-inch, standard iPads, and many phones. The holder opens approximately 5.5 to 12 inches with a 0.5 inch depth, working with many slim to standard protective cases. The press-lock suction cup attaches to clean glass or other smooth cockpit surfaces and is designed to maintain grip during normal flight conditions and light to moderate turbulence. Use it as an airplane iPad mount, iPad windshield mount, or aviation iPad mount depending on your aircraft and preferred screen position. Multi-angle adjustment supports portrait or landscape viewing, 360° rotation, tilt up/down, and left/right positioning. The quick-release pull tab removes the mount cleanly between flights with no tools, drilling, or permanent aircraft modification required. Flight-tested in Cessna, Piper, Mooney, Diamond, Cirrus, and Beechcraft cockpits, the ProAviator helps keep your charts, moving map, checklist, and approach plates visible from pre-flight to landing. Q: Can it hold other tablets? A: Yes. It fits most 7" to 12.9" tablets, including iPad Mini, iPad Air, iPad Pro models, and many phones. Q: Does it rotate? A: Yes. The mount supports 360° rotation with portrait and landscape viewing. Q: Is it easy to install? A: Yes. Press the suction cup onto a clean, smooth surface, lock it in place, and adjust the arm angle. No tools are required.
Purpose-Built for General Aviation Cockpits The ProAviator is engineered specifically for the GA cockpit, not repurposed from a car mount. This airplane iPad holder uses a 4-inch curved arm to position your iPad at eye level without crowding instruments, while the suction cup base and adjustable locking joints support real flight demands. From pre-flight planning through cruise navigation and approach briefings, this aviation iPad mount keeps your EFB exactly where you need it.
Fits iPad Mini Through iPad Pro 12.9-Inch Confirmed compatibility covers iPad Mini 4, 5, and 6; iPad 7th through 10th generation; iPad Air 3, 4, and 5; iPad Pro 11-inch generations 1 through 4; and iPad Pro 12.9-inch. The cradle adjusts from 5.5 to 12 inches wide, fitting tablets from 7 to 12.9 inches. As a tablet holder for airplane use, it works with slim to standard cases up to 0.5 inches thick; very bulky, rugged cases may require removal.
Suction Lock Grip for In-Flight Stability This suction cup iPad mount is designed to maintain secure grip during normal flight conditions and light to moderate turbulence on clean, smooth cockpit surfaces. The press-lock suction cup attaches to glass or other smooth cockpit areas, making it a practical iPad windshield mount for pilots who want stable screen placement without permanent installation.
Tool-Free Install and Quick-Release Removal The quick-release pull tab removes and reattaches the mount in seconds, with no tools, no drilling, and no permanent aircraft modification required. The rubber suction cup base bonds to clean, smooth cockpit surfaces and repositions easily to optimize your panel layout. Adjustable locking joints tighten to your preferred arm position, making this suction cup tablet mount ideal for rental, club, and shared aircraft.
Hands-Free EFB Access from Takeoff to Landing Load your flight plan during pre-flight, monitor your moving map in cruise, and reference approach plates on final without reaching for a kneeboard or balancing a tablet on your lap. This plane iPad mount lets you position your iPad in portrait or landscape view and reduce neck strain on long cross-country flights. The aviation accessory supports student pilots through experienced GA pilots and CFIs, building a cleaner cockpit workflow.