Bjorn the CyberViking — Autonomous Network Recon Device (Raspberry Pi Zero W)

Fully assembled, flashed, and tested — just add your Wi-Fi and power it on. Bjorn is an autonomous cybersecurity companion: a Viking mascot that lives on your network and continuously runs host discovery, port scanning, and service fingerprinting, logging everything to a clean web dashboard you open from any browser. It's in the same family as the Pwnagotchi, but a distinct open-source project by infinition — focused on active network recon rather than Wi-Fi handshake capture. A fantastic hands-on platform for anyone studying for Network+, Security+, or getting into ethical hacking.

What it does

• Live host discovery on your local network

• Port scanning & service fingerprinting

• Credential testing across FTP, SSH, SMB, Telnet & RDP

• Results logged to a browser dashboard

• Gamified Viking that "levels up" as it works, shown on the e-ink display

Specs

• Raspberry Pi Zero W — built-in Wi-Fi + Bluetooth

• Waveshare 2.13" e-Paper display (v4) — crisp, always-on, low-power

• 64GB microSD, pre-flashed and fully configured

• GPIO headers installed and seated to the display

• 3D Printed frosted transparent case 

What's included

One assembled Bjorn device (Pi + e-paper + frosted case) with 64GB SD pre-loaded and tested. Ready to run out of the box.

Credits

Case design: “Bjorn the Cyberviking case (Pi Zero 2 W + Waveshare v4)” by Luminous01, published on Printables and used with attribution under its Creative Commons license. Bjorn software by infinition, used under its open-source license. This device is an independent build and is not affiliated with or endorsed by either creator.

Full attribution with source links is included on a printed card in the box..

Responsible use

Sold for education and authorized security testing only. Use Bjorn exclusively on networks you own or have explicit permission to test. Buyer is responsible for lawful use.