This 3D-printed fan shrouds (pair for max stable OC) is crafted specifically for the IceRiver’s new AL0 & Rx0 mini asic miners & KS0 Pro Ultra miner will greatly enhancing its cooling capabilities. Through the delivery of focused airflow, it will lower the device's operating temperatures, boost its hash rates (when overclocked), and possibly prolong the miner life.
- Enhanced airflow capacity: Looking to maximize performance? Use this Forced air cooling shroud to achieve outstanding airflow and possibly further decrease operating temperatures.
Recommended Fan Options:120mm Muffin Fan with Speed Controller, (ac powered adjustable 12vds high cfm fans)
Important Information:For KS0 Ultra overclocking, you might need further enhancements like an upgraded power supply. It is strongly suggested to use a 230W PSU to 618GH/s or 330+W psu to 721 GH/s if overclocking
- Performance outcomes can differ based on your unique configuration and operating conditions.
- Please note that these shrouds are sold as-is, without any guarantees or warranties unless defective or otherwise stated.
Please do your research as to how these are used. If you have any questions or concerns, please don't hesitate to reach out.
This listing is for a Shroud pairs only and does not include fans, wires, screws, or miners.
Our Cooling Shrouds are made only with high heat resistant ABS Materials.
Please refer to the PetG material shroud showing heat deformation causing the it to becomes loose. If using PetG material, only use on the cooler intake side of the miner.
To ship asap, please message me about colour selection for each pair(s) purchased. any colours not in stock may require up to an extra day added to shipping time
🇺🇸 Zero Extra Fees for USA Buyers
No tariffs. No duties. No surprise charges. What you see is what you pay
