🇺🇸 Zero Extra Fees for USA Buyers

No tariffs. No duties. No surprise charges. What you see is what you pay

This 3D-printed fan shrouds are crafted specifically for the Iceriver KS0 Pro/Ultra & AL0 miner will greatly enhancing its cooling capabilities. Through the delivery of focused airflow, it will lower the device's operating temperatures, boost its hash rates (when overclocked), and possibly prolong the miner life.

Maximize the capabilities of dual shrouds:

• Reduced noise levels: Utilizing two shrouds allows each fan to operate at lower RPM, decreasing sound levels while still ensuring effective cooling.
• Enhanced airflow capacity: Looking to maximize performance? Operate both fans at their highest speed to achieve outstanding airflow and possibly further decrease operating temperatures.

Recommended Fan Options:Dual 120mm axial/muffin Fan with Speed Controller,

Important Information:For KS0 Ultra overclocking, you might need further enhancements like an upgraded power supply. It is strongly suggested to use a 230W PSU to 618GH/s or 330+W psu to 721 GH/s  if overclocking 

• Performance outcomes can differ based on your unique configuration and operating conditions.
• Please note that these shrouds are sold as-is, without any guarantees or warranties.

Please do your research as to how these are used. If you have any questions or concerns, please don't hesitate to reach out.

This listing is for the Two Shrouds only and does not include fans, wires, screws, or miners. 

Our Cooling Shrouds are made only with high heat resistant ABS or Petg  Materials.