I’ve had this printer for nearly two years and have taken very good care of it, keeping it in nearly perfect working condition. It still works and prints completely normally, and it has been an extremely reliable “workhorse” printer for me.

One thing I want to be transparent about is that, the last time I checked, the X/Y belts and POM wheels were recommended for replacement. However, they have not affected the printer’s performance or print quality. It still prints normally, but I wanted to mention this in case you experience any issues in the future.

There is also a small cosmetic/mechanical issue with one of the screws near the hot end/extruder. When I was replacing the hot end, one of the screws that I believe holds it in place (I may be mistaken about its exact purpose) became stripped. I used a Dremel to cut a small notch into the screw so it could still be removed with a small flat-head screwdriver if needed. This has not affected print quality or any other functionality.

Other than those things, the printer has been very well maintained and has given me no problems. It’s an absolutely fantastic printer, capable of print speeds of up to 500 mm/s with a 220 × 220 × 250 mm build volume.

I’m only selling it because I decided to upgrade to a newer, more advanced printer.

If you have any questions, feel free to contact me through . I’ll be happy to provide any additional information or answer any questions you may have.