UBB Store

VINTAGE FOXCONN SCSI 5-Port Backplane (FC-9666 Ver 1.0),CONVERTS LVD TO LVD WIDE
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
VINTAGE FOXCONN SCSI 5-Port Backplane (FC-9666 Ver 1.0),CONVERTS LVD TO LVD WIDE
Price: US $24.99
VINTAGE FOXCONN SCSI 5-Port Backplane(FC-9666 Ver 1.0),CONVERTS LVD TO LVD WIDE
NEW OLD STOCKTESTED AND WORKING(SEE PHOTOS)
The Foxconn SCSI 5-Port Backplane (FC-9666 Ver 1.0) is a vintage enterprise-grade hardware component.It is primarily designed to act as a pass-throughand power distribution hub forlegacy hard drive enclosures and server chassis.
The FOXCONN SCSI 5-Port Backplane (FC-9666 Ver 1.0)is an OEM rackmount backplanehistorically used in server enclosures (often from ETrunk).
It is designed to mount up to 5 SCA-II (80-pin) HOT-SWAP hard drives and route them to a single hardwareLVD (68PIN) RAID controller or host bus adapter.
Key SpecificationsDrive Bays: 5 ports(supporting 5 x SCA-II 80-pin hot-swap drives)
SCSI Standard: Ultra-320 (U320) SCSI, which supports up to320 MB/s data transfer rates
Connectors: 5 X 80-pin SCA (Single Connector Attachment) for drive side; standard SCSI data ports(e.g., Ultra320 LVD/SE) and standard 4-pin Molex power connectors
Monitoring: includes headers for drive activity LEDs and enclosure management/SES
In SCSI technology, LVD (Low Voltage Differential)defines the electrical signaling method used fordata transmission,while "Wide" refers to the bus or port width.
LVD Signaling: A low-power, noise-resistant method allowing for faster speeds and longer cable runs.LVD Wide: Indicates an LVD port that transfers data across a 16-bit wide data path, doubling the data throughput(e.g., 160 MB/s or 320 MB/s) compared to narrower 8-bit versions.
The Foxconn SCSI 5-Port Backplane (FC-9666 Ver 1.0) is generally not self-terminating by default.In standard parallel SCSI configurations, this type of backplane relies on physical termination.To properly terminate your SCSI bus with this backplane, you will need to Install a Terminator:
You must attach a multi-mode LVD/SE or Ultra-SCSI terminator Foxconn Ultra 160/320 SCSI Terminator tothe last drive slot or the terminal connector on the SCSI ribbon cable.
68 PIN LVD CABLE PROVIDED TO CONNECT BACKPLANE TO SCSI CONTROLLER BOARD(TERMINATOR NOT INCLUDED)
WHOLESALE PKG ONLYNO OTHER MOUNTING HARDWARE INCLUDED

Buy Now