Error 127 is corruption for sure, but how it can be due to using and repairing at the same time I'm not sure. I was under the impression that the table locks while it is being repaired. Am I wrong?

Ian, might also be a good idea at some point to have the hard drives checked. If you had one bad drive, with the way your drives are setup. you would see exactly this. I think this is lower on the list of "could be the problem" than the previously mentioned things to check, but surely it needs to be on the list.

As I said to you before, I think it's more a combination of problems than it is one single cause.

This thread for sale. Click here! [Linked Image from navaho.infopop.cc]